What should I pay attention to when installing the all-steel test bench?

      The bottom cabinet of the test bench is arranged according to the drawings. All the cabinets of the same steel-wood test bench are adjusted to the same level on the upper edge of the base cabinet at the installation position (it is absolutely forbidden to add wood chips and the like without adjusting the level). After the horizontal adjustment is completed, the gap between the bottom cabinet of the experimental platform and the base cabinet is required to be no more than 3 mm, and the upper and lower errors of the joint are not more than 2 mm.

      If it is necessary to connect all the base cabinets together, it is necessary to connect them after the level is adjusted. When connecting, the distance between the even and tight joints at the joints must not exceed 2 mm, and the error of the upper and lower joints cannot exceed 3 mm.

      The steel-wood test bench panels should be as close as possible to their integrity, and joints should be minimized and not longitudinally connected. Check whether there is a water stop groove under the outer edge of the test bench panel, check the position and interface of the water, electricity, gas and air duct, check whether there is any deviation from the design, and communicate in time to determine the final solution.

      The use of laboratory furniture is often in contact with water, electricity, gas, chemicals and materials, as well as equipment. Therefore, in the pursuit of the flexibility of the experimental environment and the flexibility of installation and installation, the company’s design and material design standards for furniture Higher requirements have also been raised.